How to measure out your window for roller blinds

How to measure your window for roller blinds

Measuring is a straightforward procedure, merely information technology's the one surface area that stresses most people out. Why? Well, people fright getting information technology wrong.

But residuum assured. To measure your window for our roller blinds, all you demand is a tape measure, pen and a slice of paper. "Measure twice, cutting once" goes the advice – and nosotros agree.

The first determination y'all need to make is whether yous would prefer an 'inside' or 'outside' mountain. Both options can await cracking and the choice comes down to your personal manner, but the process for measuring is slightly different. Hither's how to go virtually it.

How to measure for an 'inside' mount

For a great result, ensure you have a minimum window depth of 60mm. This ways the bullheaded will fit neatly inside the recess. If the depth is less than 60mm the blind will protrude out of the recess.

  1. To start, describe a square or rectangle on a piece of paper – this is your window frame. If you are measuring multiple windows, give them a characterization, such as 'kitchen window 1' so you don't get confused later on.
  2. Grab your tape measure and place it within the inside window recess. Measure across the inside of frame from one terminate to the next. Do this at the pinnacle and bottom of the frame every bit not all windows are perfectly square.

    Write down the width of your window frame.

    Note that Zone Interiors Roller Blinds include an allowance for installation brackets – see pack for details and conform appropriately.

  3. Measure the length (vertical drop) from the top of the inside recess to the base of the window sill.

    Write down the length of your window frame.

  4. Double-check both measurements.

How to measure for 'outside' mount

The instructions given here are for windows with architraves (timber or metal frame). If you don't take an architrave just would like an outside mount, add together a minimum of 100mm to the width and length of your measurements.

If yous are installing your roller blind to a gyprock or plaster wall, make sure you locate the stud in the wall and ensure yous secure your bullheaded to the stud. It gives your bullheaded the back up it needs to hold the weight of the bullheaded.

  1. To start, draw a foursquare or rectangle on a piece of newspaper – this is your window frame. If you lot are measuring multiple windows, requite them a label, such equally 'kitchen window 1' so you don't get confused subsequently on.
  2. If yous have an architrave, catch your tape measure and place information technology on the outer border of the architrave. Measure along the width of the window to the opposite edge. Write downward the width of your window frame.
  3. Measure the the length (vertical drop) from the top of the architrave to where you would like the blind to end. This may exist the stop of the architrave, or you may wish for the blind to end at a unlike point – the floor for example.
  4. Double-bank check both measurements.

Check out our article on installing your DIY roller blinds for more a handy guide of your next steps.

And that's it. It's equally easy as one, 2, three – check!

Related Articles